You can set to dump Programs, Combis, Global, Sequence Data or All. Set your software to receive the bulk dump Set your M1 as follows in the global section: Here are the settings that will let you do this on the M1: Each synthesizer is set up differently, so refer to your owners manuel on how to transmit a “Bulk Dump” or “Sysex Dump” from your computer to your synth. A simple midi interface will connect to your computers USB port and enable you to load and save sounds to your computers hard drive. The cards are also expensive and do not hold much memory (usually only one bank of sounds can fit on a typical RAM card).Īs described in our “Sysex Made Simple article”, there are better ways to do things. You can change the battery on “some” cards, but even if you do any sounds that were on the card are gone. That makes the card useless in most cases. Even if you do happen to find one, there is a good chance that the internal battery on the card is dead.

The ROM, RAM and PCM cards that fit into the M1 card slots have not been made in many years and are hard to find. NOTE: These settings will also work with the Korg M1R Rack Module as well as the Korg T-Series (T1, T2, T3 and T3-EX). We have a great collection which will get your M1 back on it’s feet again, but there are a few important things you should know. You can find more info on all our Korg M1 sounds and Patches over here. The Korg M1 is one of, if not the best selling synthesizers of all time so there are a lot of M1 owners out there still looking for new sounds.

Korg m1 factory preload data